1. When using the High Vacuum Central Dust Collection System, you must first check whether the various system pipe valves of the equipment are intact, whether the selection and ratio of the absorption liquid agent are correct, and the absorption solution must be supplemented in time. When booting, turn on the pump for 3-5 minutes before turning on the fan. When turning off this purification system, you should first turn off the fan before turning off the pump. Do not open it. Otherwise, the motor and block the fillers will be burned out to affect the purification effect.

2. For High Vacuum Central Dust Collection System's fan and water pump wiring cannot be chaotic, they should ensure that their steering is correct and must not be reversed, otherwise the motor will be damaged and can cause accidents.

3. After the device is delivered, the unit shall send a special person to keep it and check it regularly. It is found that the equipment is abnormal or leaky. It should be stopped and used after being repaired.

4. The equipment is installed outdoors, and the water pump wind motor should make a rain cover to prevent the motor from moisture. Whether

Installing indoor and outdoor, if a glass reinforcement or plastic fan is selected, a protective cover must be installed to prevent screws from looseness, bearing damage or sundry into debris, and damaging the impeller and causing accidents.

5. The replacement and distribution of the purification solution: The formula ratio of our factory on the purification absorption solution is determined by the different gas sources of the user unit and the concentration of the concentration. After the normal acceptance of the device is qualified, the user management personnel will be provided.

high vacuum central dust collection system https://www.kaisenfilter.com/high-vacuum-central-dust-collection-system.html